Materials Needed:
Twist Off Bottle Caps
Charms, Dangles, beads, etc.
Laminating Machine or Lamination paper
Computer Graphics or other photos/pictures to use
Glue (welbond and goop glue works well)
Jump Rings
INSTRUCTIONS:
Print off graphics or get old photos/cards, etc. and cut out a 1 inch circle that will be used as your photo
for the bottle cap.
If you have a 1 inch hole punch, that would work perfect for cutting.
Laminate the front of the graphics and then glue the backs to adhere it to the round rubber seal of the cap.
If you can get the seal off, the photos would sit better, but it's hard to get the seal off from the cap.
Drill a hole for the jump rings and beads if you want to add them to it.
*NOTE FROM EILEEN:
I used Weldbond on some pins and goop glue on the others.
I Wore one into Curves this morning, and it did not fall apart. So far so good.
You are probably wondering where to get the bottle caps? Well, here are two cheap online resources Eileen found:
BOTTLE CAP RESOURCE ONE
BOTTLE CAP RESOURCE TWO
